Home › HYBRID SYSTEM › HYBRID TRANSMISSION / TRANSAXLE › ELECTRONIC SHIFT LEVER SYSTEM

ELECTRONIC SHIFT LEVER SYSTEM > DTC CHECK / CLEAR

for Preparation Click here



CHECK DTC
  1. Connect the Techstream to the DLC3.

  2. Turn the power switch ON (IG).

  3. Read the DTC by following the prompts on the tester screen.

    HINT:
    Refer to the Techstream operator's manual for further details.


CLEAR DTC
  1. Connect the Techstream to the DLC3.

  2. Turn the power switch ON (IG).

  3. Erase the DTC by following the directions on the tester screen.

    HINT:
    Refer to the Techstream operator's manual for further details.