Home › HYBRID SYSTEM › HYBRID TRANSMISSION / TRANSAXLE › ELECTRONIC SHIFT LEVER SYSTEM

DTC    C2301    Shift Changing Time Malfunction

for Preparation Click here


DESCRIPTION

The transmission control ECU receives a P position switch signal from the hybrid vehicle control ECU and then activates the shift control actuator. At the same time, the transmission control ECU detects the length of time it takes for the parking lock mechanism to switch. The transmission control ECU outputs this DTC when this length of time is longer than specification.

DTC No.
DTC Detection Condition
Trouble Area
C2301
When both conditions below are met:
  1. Power switch ON (IG).
  2. There is an internal abnormality in the shift control actuator for 2 seconds or more (the parking lock motor runs idle).
  1. Shift control actuator
  2. Transmission control ECU

INSPECTION PROCEDURE

1.CHECK SHIFT CONTROL ACTUATOR


    G030192E01
  1. Remove the 3 bolts and transmission case cover.

  1. Remove the 3 bolts.

  1. Slightly pull the shift control actuator from the hybrid vehicle transaxle so that the shift control actuator can be turned.

  1. Turn the shift control actuator.

    OK:
    The shift control actuator turns smoothly.

    HINT:
    There may be an internal actuator abnormality if the actuator does not turn smoothly.



NG
REPLACE SHIFT CONTROL ACTUATOR
OK

REPLACE TRANSMISSION CONTROL ECU