Home › HYBRID SYSTEM › HYBRID TRANSMISSION / TRANSAXLE › ELECTRONIC SHIFT LEVER SYSTEM

DTC    C2307    Power Source Malfunction

for Preparation Click here


DESCRIPTION

The shift control actuator consists of the parking lock motor and the rotation angle sensor. The transmission control ECU receives a P position switch signal from the hybrid vehicle control ECU and activates the parking lock motor by controlling current, causing the parking lock mechanism to switch. The transmission control ECU outputs this DTC when it detects a malfunction in the parking lock motor system and/or the ground circuit.

DTC No.
DTC Detection Condition
Trouble Area
C2307
When both conditions below are met:
  1. Power switch ON (IG)
  2. The parking lock motor current is 50 A or more, or there is an open in the terminal E1 circuit of the transmission control ECU for 0.1 seconds or more.
  1. Transmission control ECU
  2. Wire harness or connector
  3. Parking lock motor (Shift control actuator)

WIRING DIAGRAM


C126770E02


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (TRANSMISSION CONTROL ECU - BODY GROUND)


    B118155E16
  1. Disconnect the T4 ECU connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    T4-15 (E1) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2.CHECK WIRE HARNESS (TRANSMISSION CONTROL ECU - BODY GROUND)


    B118155E13
  1. Measure the voltage of the wire harness and connector.

    Standard voltage:
    Tester Connection
    Specified Condition
    T4-10 (MWA) - Body ground
    Below 1 V
    T4-11 (MVA) - Body ground
    Below 1 V
    T4-12 (MUA) - Body ground
    Below 1 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE TRANSMISSION CONTROL ECU