Home › HYBRID SYSTEM › HYBRID TRANSMISSION / TRANSAXLE › ELECTRONIC SHIFT LEVER SYSTEM

DTC    C2310    Open or Short Circuit in BATT

for Preparation Click here


DESCRIPTION

The auxiliary battery voltage is constantly applied to terminal BATT. The terminal BATT voltage is used to power the transmission control ECU memory. The transmission control ECU outputs this DTC when it detects a malfunction related to terminal BATT.

DTC No.
DTC Detection Condition
Trouble Area
C2310
When both conditions below are met:
  1. Power switch ON (IG)
  2. Terminal BATT voltage of the transmission control ECU is 10 V or less for 1 second or more.
  1. P CON MAIN fuse
  2. Transmission control ECU
  3. Wire harness or connector

HINT:
When there is an open or short in the BATT circuit, information on the actuator position ("P position" or "non-P position") stored in the ECU is cleared every time the power switch is turned OFF. Therefore, the ECU works to recognize the position each time the power switch is turned ON (IG). As a result, the time from when the power switch is turned ON (IG) until "READY ON" is indicated may become longer than normal.


WIRING DIAGRAM


C126771E01


INSPECTION PROCEDURE

1.INSPECT FUSE (P CON MAIN)


    F047675E01
  1. Remove the P CON MAIN fuse from the engine room relay block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
INSPECT FOR SHORT IN ALL COMPONENTS CONNECTED TO FUSE AND REPAIR OR REPLACE THEM IF NEEDED, AND REPLACE FUSE
OK


2.READ VALUE OF TECHSTREAM (BATT VOLTAGE)
  1. Check the Data List for proper functioning of the transmission control ECU.

    Transmission control ECU 
    Tester Display
    Measurement Item / Range
    Normal Condition
    Diagnostic Note
    Battery Voltage Value
    BATT voltage value / min: 0 V, max: 20 V
    Actual power supply voltage 9 to 14 V
    -

    Standard voltage:
    9 to 14 V



OK
REPLACE TRANSMISSION CONTROL ECU
NG


3.CHECK WIRE HARNESS (TRANSMISSION CONTROL ECU - P CON MAIN FUSE)


    C177052E01
  1. Disconnect the T4 ECU connector.

  1. Remove the P CON MAIN fuse from the engine room relay block.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    T4-13 (BATT) - 2 (P CON MAIN Fuse)
    Below 1 Ω
    T4-13 (BATT) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPAIR OR REPLACE HARNESS AND CONNECTOR (P CON MAIN FUSE - BATTERY)