Home › HYBRID SYSTEM › HYBRID TRANSMISSION / TRANSAXLE › ELECTRONIC SHIFT LEVER SYSTEM

DTC    C2311    HV Communication Line Malfunction

for Preparation Click here


DESCRIPTION

The transmission control ECU receives a P position switch signal from the hybrid vehicle control ECU and activates the parking lock motor by controlling current, causing the parking lock mechanism to switch. The transmission control ECU outputs this DTC when it detects a communication error between the hybrid vehicle control ECU and the transmission control ECU.

DTC No.
DTC Detection Condition
Trouble Area
C2311
When both conditions below are met:
  1. Power switch ON (IG)
  2. Signals from the hybrid control ECU cannot be received, or there is a problem with a pulse signal from the hybrid vehicle control ECU for 1 second or more.
  1. Transmission control ECU
  2. Hybrid vehicle control ECU
  3. Wire harness or connector

WIRING DIAGRAM


C178116E01


INSPECTION PROCEDURE

1.CHECK TRANSMISSION CONTROL ECU (PCON SIGNAL)


    C136043E01
  1. Check output waveform.

    1. Turn the power switch ON (IG).

    2. Using an oscilloscope, check the output waveform of the transmission control ECU connector.

      OK:
      The output waveform appears as shown in the illustration.

      Item
      Contents
      Symbols
      PCON - E1
      Tool setting
      5 V/DIV., 20 msec./DIV.
      Vehicle condition
      Power switch ON (IG)



OK
REPLACE TRANSMISSION CONTROL ECU
NG


2.CHECK WIRE HARNESS (HYBRID VEHICLE CONTROL ECU - TRANSMISSION CONTROL ECU)


    C126779E01
  1. Disconnect the T4 and H17 ECU connectors.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection (Symbols)
    Specified Condition
    T4-7 (PCON) - H17-9 (PCON)
    Below 1 Ω
    T4-7 (PCON) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE HYBRID VEHICLE CONTROL ECU