Home › HYBRID SYSTEM › HYBRID TRANSMISSION / TRANSAXLE › ELECTRONIC SHIFT LEVER SYSTEM

DTC    C2315    HV System Malfunction

for Preparation Click here


DESCRIPTION

The transmission control ECU receives a P position switch signal from the hybrid vehicle control ECU and activates the parking lock motor by controlling current, causing the parking lock mechanism to switch. When the hybrid control ECU detects a malfunction with the P position switch or P position signal, it sends an information signal to the transmission control ECU. After receiving this signal, the transmission control ECU outputs this DTC.

DTC No.
DTC Detection Condition
Trouble Area
C2315
When both conditions below are met:
  1. Power switch ON (IG)
  2. A malfunction signal from the hybrid control ECU is received for 1 second or more.
  1. Hybrid vehicle control ECU
  2. P position switch
  3. Transmission control ECU
  4. Wire harness or connector

WIRING DIAGRAM


C126772E01


INSPECTION PROCEDURE

1.CHECK OTHER DTC OUTPUT (BESIDES DTC C2315)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch ON (IG).

  1. Turn the Techstream on.

  1. Read the DTCs.

    Result 
    Result
    Proceed to
    No output
    A
    P0851-579, P0852-580, P3102-597, 598 and 599
    B

    HINT:
    1. DTCs P0851 and P0852 indicate P position switch malfunctions. DTC P0851-579 indicates "short to ground" and P0852-580 indicates "open" or "short to +B".
    1. DTC P3102 indicates a P position signal error. DTC P3102-597 indicates "short to ground", P3102-598 indicates "short to +B", and P3102-599 indicates "duty ratio error".



B
REPAIR CIRCUIT INDICATED BY OUTPUT CODE
A

REPLACE HYBRID VEHICLE CONTROL ECU