Home › HYBRID SYSTEM › HYBRID TRANSMISSION / TRANSAXLE › ELECTRONIC SHIFT LEVER SYSTEM

ELECTRONIC SHIFT LEVER SYSTEM > "P" Position Switch Indicator Light Circuit

for Preparation Click here


DESCRIPTION

The parking lock switch indicator light comes on or goes off to indicate the on/off status of the P position switch and blinks to indicate malfunction conditions of the system.

WIRING DIAGRAM


C126775E01


INSPECTION PROCEDURE

1.CHECK INDICATOR LIGHT
  1. Inspect the indicator light condition by operating the P position switch.

    Result 
    Condition
    Proceed to
    Indicator light does not go off.
    A
    Indicator light does not come on.
    B



B
Go to step 3
A


2.CHECK WIRE HARNESS (TRANSMISSION CONTROL ECU - P POSITION SWITCH)


    B118155E17
  1. Disconnect the T4 ECU connector.

  1. Disconnect the M11 switch connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    T4-9 (IND) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE TRANSMISSION CONTROL ECU 

3.INSPECT FUSE (P CON MAIN)


    F047675E01
  1. Remove the P CON MAIN fuse from the engine room relay block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
INSPECT FOR SHORT IN ALL COMPONENTS CONNECTED TO FUSE AND REPAIR OR REPLACE THEM IF NEEDED, AND REPLACE FUSE
OK


4.CHECK WIRE HARNESS (TRANSMISSION CONTROL ECU - BATTERY)


    B118155E17
  1. Disconnect the T4 ECU connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Specified Condition
    T4-9 (IND) - Body ground
    9 to 14 V



OK
REPLACE TRANSMISSION CONTROL ECU
NG


5.CHECK WIRE HARNESS (TRANSMISSION CONTROL ECU - P POSITION SWITCH)


    C126780E01
  1. Disconnect the T4 ECU connector.

  1. Disconnect the M11 switch connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    T4-9 (IND) - M11-6
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


6.CHECK WIRE HARNESS (P POSITION SWITCH - BATTERY)


    C126781E01
  1. Disconnect the M11 switch connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Specified Condition
    M11-5 - Body ground
    9 to 14 V



OK
REPLACE P POSITION SWITCH
NG

REPAIR OR REPLACE HARNESS AND CONNECTOR