Home › HYBRID SYSTEM › HYBRID TRANSMISSION / TRANSAXLE › ELECTRONIC SHIFT LEVER SYSTEM

DTC    C2312    Power Source Control ECU Communication Line Malfunction

for Preparation Click here


DESCRIPTION

The transmission control ECU receives power switch condition signals (OFF / ON (ACC) / ON (IG)) from the power source control ECU. The transmission control ECU outputs this DTC when it does not receive the signals.

DTC No.
DTC Detection Condition
Trouble Area
C2312
When both conditions below are met:
  1. Power switch ON (IG)
  2. Signals from the power source control ECU cannot be received for 10 seconds or more.
  1. Transmission control ECU
  2. Power source control ECU

WIRING DIAGRAM


C177056E02


INSPECTION PROCEDURE

1.READ VALUE OF TECHSTREAM (P SPLY OFF SIGNAL)
  1. Check the Data List for proper functioning of the transmission control ECU.

    Transmission control ECU 
    Tester Display
    Measurement Item / Range
    Normal Condition
    Diagnostic Note
    P Sply OFF Prepare Rqst Sig
    Power supply off preparation request signal / ON or OFF
    ON: Power is turned off by power source control ECU after receiving power switch OFF signal
    OFF: Any other condition
    -

    OK:
    ON is displayed.



NG
REPLACE POWER SOURCE CONTROL ECU
OK

REPLACE TRANSMISSION CONTROL ECU