Home › BODY ELECTRICAL › DOOR LOCK › SMART KEY SYSTEM

SMART KEY SYSTEM > Key Cancel Switch does not Operate

for Preparation Click here


DESCRIPTION

When the key cancel switch is ON, all entry functions will stop operating. If the key cancel switch is not turned ON but all entry functions stop operating, one of the following is malfunctioning: 1) key cancel switch, 2) certification ECU, or 3) wire harness.

WIRING DIAGRAM


B115339E06


INSPECTION PROCEDURE

1.CHECK WIRELESS DOOR LOCK OPERATION
  1. Check that the wireless door lock function operates normally.

    OK:
    Wireless door lock function operates normally.



NG
GO TO WIRELESS DOOR LOCK CONTROL SYSTEM (w/ SMART KEY SYSTEM)
OK


2.READ VALUE OF TECHSTREAM (KEY CANCEL SWITCH)
  1. Check the Data List for proper functioning of the certification ECU.

    Certification ECU 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Key Cancel SW
    Key cancel switch /
    ON or OFF
    ON: Key cancel switch is ON
    OFF: Key cancel switch is OFF
    -

    OK:
    OFF (key cancel switch is OFF) appears on the screen.



OK
REPLACE CERTIFICATION ECU
NG


3.INSPECT KEY CANCEL SWITCH
B050965E01
  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Not pushed (OFF)
    10 kΩ or higher
    1 - 2
    Pushed (ON)
    Below 1 Ω



NG
REPLACE KEY CANCEL SWITCH
OK


4.CHECK WIRE HARNESS (KEY CANCEL SWITCH - CERTIFICATION ECU AND BODY GROUND)
B079797E01
  1. Disconnect S12 switch connector.

  1. Disconnect S11 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    S12-1 - S11-25 (CNSL)
    Below 1 Ω
    S12-2 - Body ground
    Below 1 Ω
    S12-1 or S11-25 (CNSL) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE CERTIFICATION ECU