Home › BODY ELECTRICAL › DOOR LOCK › SMART KEY SYSTEM

SMART KEY SYSTEM > Driver Side Door Entry Lock and Unlock Functions do not Operate

for Preparation Click here


DESCRIPTION

Both the entry lock and unlock functions do not operate when: 1) nothing is output from the door electrical key oscillator LH, 2) the smart key system is disabled through customization, or 3) the entire power door lock control system is malfunctioning.

WIRING DIAGRAM


B128889E01


INSPECTION PROCEDURE

1.CHECK MANUAL DOOR LOCK AND UNLOCK OPERATION
  1. Check that the manual door lock and unlock function operates normally.

    OK:
    Manual door lock and unlock function operates normally



NG
GO TO POWER DOOR LOCK CONTROL SYSTEM
OK


2.PERFORM ACTIVE TEST BY TECHSTREAM (DOOR ELECTRICAL KEY OSCILLATOR LH)
  1. Select the Active Test, use the Techstream to generate a control command, and then check that the oscillator operates.

    Certification ECU 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    D Transmitter
    Driver side transmitter
    ON / OFF
    -

    OK:
    When key is brought close to door oscillator that is ON, indicator on key illuminates.



OK
REPLACE CERTIFICATION ECU
NG


3.CHECK WIRE HARNESS (DOOR ELECTRICAL KEY OSCILLATOR LH - CERTIFICATION ECU, BATTERY AND BODY GROUND)
B079781E01
  1. Disconnect the D16 oscillator connector.

  1. Disconnect the S11 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    D16-4 (CLG) - S11-13 (CLG1)
    Below 1 Ω
    D16-4 (CLG) or S11-13 (CLG1) - Body ground
    10 kΩ or higher
    D16-8 (GND) - Body ground
    Below 1 Ω

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Specified Condition
    D16-1 (+B) - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4.CHECK DOOR ELECTRICAL KEY OSCILLATOR LH (CLG VOLTAGE)
B080049E01
  1. Measure the voltage between the terminals of the connector when the power switch is operated.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D16-4 (CLG) - Body ground
    Power switch OFF
    Alternating between 5 V and below 1 V
    Power switch ON (IG)
    Below 1 V



NG
REPLACE DOOR ELECTRICAL KEY OSCILLATOR LH
OK

REPLACE CERTIFICATION ECU