Home › BODY ELECTRICAL › DOOR LOCK › SMART KEY SYSTEM

SMART KEY SYSTEM > Driver Side Door Entry Lock Function does not Operate

for Preparation Click here


DESCRIPTION

When the touch sensor inside the outside door handle LH is touched, the certification ECU sends a request signal to the door electrical key oscillator LH. The key receives this request and transmits its ID code. Upon receiving the ID code, the certification ECU determines that the key is outside the vehicle and sends a lock signal to the driver door lock through the instrument panel junction block (multiplex network body ECU).

WIRING DIAGRAM


B128891E03


INSPECTION PROCEDURE

1.CHECK MANUAL DOOR LOCK OPERATION
  1. Check that the manual door lock function operates normally.

    OK:
    Manual door lock function operates normally.



NG
GO TO POWER DOOR LOCK CONTROL SYSTEM
OK


2.READ VALUE OF TECHSTREAM (LOCK SWITCH)
  1. Check the Data List for proper functioning of the certification ECU.

    Certification ECU 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    D Trigger SW
    D-door trigger switch /
    ON or OFF
    ON: Lock switch is pushed
    OFF: Lock switch is not pushed
    -

    OK:
    ON (lock switch is pushed) appears on the screen.



OK
REPLACE CERTIFICATION ECU
NG


3.CHECK WIRE HARNESS (ELECTRICAL KEY ANTENNA LH - CERTIFICATION ECU AND BODY GROUND)
B080378E01
  1. Disconnect E8 antenna connector.

  1. Disconnect S11 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E8-3 (TRG+) - S11-5 (TSW1)
    Below 1 Ω
    E8-1 (TRG-) - Body ground
    Below 1 Ω
    E8-3 (TRG+) or S11-5 (TSW1) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4.INSPECT ELECTRICAL KEY ANTENNA LH
E067622E02
  1. Measure the resistance of the outside door handle.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (TRG-) - 3 (TRG+)
    Switch pushed
    Below 1 Ω
    1 (TRG-) - 3 (TRG+)
    Switch not pushed
    10 kΩ or higher



NG
REPLACE ELECTRICAL KEY ANTENNA LH
OK

REPLACE CERTIFICATION ECU