Home › BODY ELECTRICAL › DOOR LOCK › SMART KEY SYSTEM

SMART KEY SYSTEM > Key Luggage Compartment Lock-in Prevention Function does not Operate

for Preparation Click here


DESCRIPTION

With the key inside the luggage compartment, press the back door opener switch. The certification ECU uses the back door oscillators (outer and inner) to output a request signal. The back door outer oscillator cannot verify an ID code in this situation. The key receives the request and transmits its ID code to the antenna. The ID code is then sent to the certification ECU through the back door inner oscillator in order to be confirmed by the certification ECU. If the ID code is verified, the certification ECU sends a back door open signal to the driver side junction block (main body ECU) using the multiplex communication line and stops outputting request signals. The back door then can be opened.

WIRING DIAGRAM


B128889E04


INSPECTION PROCEDURE

1.CHECK BACK DOOR ENTRY UNLOCK FUNCTION OPERATES
  1. Check that the back door entry unlock function operates normally.

    OK:
    Back door entry unlock function operates normally.



NG
GO TO PROBLEM SYMPTOMS TABLE
OK


2.CHECK WIRE HARNESS (LUGGAGE ELECTRICAL KEY OSCILLATOR (INNER) - BATTERY AND BODY GROUND)
B106249E01
  1. Disconnect the L6 connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Specified Condition
    L6-1 (+B) - Body ground
    10 to 14 V

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    L6-5 (GND) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.PERFORM ACTIVE TEST BY TECHSTREAM (LUGGAGE ELECTRICAL KEY OSCILLATOR (INNER))
  1. Select the Active Test, use the Techstream to generate a control command, and then check that the oscillator (inner) operates.

    Certification ECU 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    In Bdr Tnsmttr
    Back door inner transmitter
    ON / OFF
    -

    OK:
    ON (key is in luggage room) appears on the screen.



NG
REPLACE LUGGAGE ELECTRICAL KEY OSCILLATOR (INNER)
OK


4.CHECK WIRE HARNESS (CERTIFICATION ECU - LUGGAGE ELECTRICAL KEY OSCILLATOR (INNER))
B079793E04
  1. Disconnect the S11 ECU connector.

  1. Disconnect the L6 oscillator connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    S11-38 (CLG7) - L6-3 (CLG)
    Below 1 Ω
    S11-38 (CLG7) or L6-3 (CLG) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE CERTIFICATION ECU