Home › ENGINE › 1NZ-FXE ENGINE CONTROL SYSTEM › SFI SYSTEM

SFI SYSTEM > VC Output Circuit

for Preparation Click here


DESCRIPTION

The VC voltage (5 V) is generated in the ECM. The voltage is used to supply power to the throttle position sensor, canister pump module, etc.

WIRING DIAGRAM


A151909E01


INSPECTION PROCEDURE

1.CHECK MIL
  1. Check that the MIL (Malfunction Indicator Lamp) lights up when turning the power switch ON (IG).

    OK:
    MIL lights up.



OK
SYSTEM IS OK
NG


2.CHECK CONNECTION BETWEEN TECHSTREAM AND ECM
  1. Connect Techstream to the DLC3.

  1. Turn the power switch ON (IG) and turn Techstream ON.

  1. Check the connection between Techstream and ECM.

    Result:
    Condition
    Proceed to
    Communication is possible
    A
    Communication is not possible
    B



A
GO TO MIL CIRCUIT
B


3.CHECK ECM (VC VOLTAGE)


    A119979E47
  1. Turn the power switch ON (IG).

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Specified Condition
    E4-18 (VC) - E5-28 (E1)
    Voltage is not 5 V


NEXT


4.CHECK MIL (THROTTLE POSITION SENSOR)
  1. Disconnect the T3 throttle body connector.

  1. Turn the power switch ON (IG).

  1. Check the MIL.

    Result:
    Condition
    Proceed to
    MIL illuminates
    A
    MIL does not illuminate
    B



A
REPLACE THROTTLE BODY
B


5.CHECK MIL (WATER VALVE)
  1. Disconnect the W5 water valve connector.

  1. Turn the power switch ON (IG).

  1. Check the MIL.

    Result:
    Condition
    Proceed to
    MIL illuminates
    A
    MIL does not illuminate
    B



A
REPLACE WATER VALVE
B


6.CHECK MIL (CANISTER PUMP MODULE)
  1. Disconnect the V7 canister pump module connector.

  1. Turn the power switch ON (IG).

  1. Check the MIL.

    Result:
    Condition
    Proceed to
    MIL illuminates
    A
    MIL does not illuminate
    B



A
REPLACE CHARCOAL CANISTER ASSEMBLY
B


7.CHECK MIL (VAPOR PRESSURE SENSOR)
  1. Disconnect the V6 vapor pressure sensor connector.

  1. Turn the power switch ON (IG).

  1. Check the MIL.

    Result:
    Condition
    Proceed to
    MIL illuminates
    A
    MIL does not illuminate
    B



A
REPLACE VAPOR PRESSURE SENSOR
B


8.CHECK HARNESS AND CONNECTOR (ECM - BODY GROUND)
A065743E90
  1. Disconnect the T3 throttle body connector.

  1. Disconnect the W5 water valve connector.

  1. Disconnect the V7 canister pump module connector.

  1. Disconnect the V6 vapor pressure sensor connector.

  1. Disconnect the E4 ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    E4-18 (VC) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM