Home › ENGINE › 1NZ-FXE ENGINE MECHANICAL › ENGINE ASSEMBLY

ENGINE ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT INTAKE MANIFOLD


    A130329
  1. Using a precision straightedge and feeler gauge, measure the surface contacting the cylinder head for warpage.

    Maximum warpage:
    0.10 mm (0.004 in.)

    Using a precision straightedge and feeler gauge, measure the surface contacting the cylinder head for warpage.



2. INSPECT EXHAUST MANIFOLD


    A130330
  1. Using a precision straightedge and feeler gauge, measure the surface contacting the cylinder head for warpage.

    Maximum warpage:
    0.70 mm (0.028 in.)

    If the warpage is greater than the maximum, replace the manifold.