Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Smart Key System)

WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Smart Key System) > TERMINALS OF ECU

for Preparation Click here



CHECK DRIVER SIDE JUNCTION BLOCK (MAIN BODY ECU)

B127174E01

  1. Disconnect the 1A, 1B, 1D, 1E and 1J junction block connectors.

  2. Measure the resistance and voltage of the wire harness side connectors.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    GND (1E-17) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    SIG (1B-1) - Body ground
    W - Body ground
    Ignition power supply
    Power switch OFF
    Below 1 V
    Power switch ON (IG)
    10 to 14 V
    ACC (1J-5) - Body ground
    G - Body ground
    Ignition power supply
    Power switch OFF
    Below 1 V
    Power switch ON (ACC)
    10 to 14 V
    ECUB (1A-30) - Body ground
    R - Body ground
    +B (ECUB) power supply
    Always
    10 to 14 V
    KSW (1E-26) - Body ground
    Y - Body ground
    Key unlock warning switch input
    No key in key slot
    10 kΩ or higher
    Key inserted
    Below 1 Ω
    DCTY (1D-21) - Body ground
    V - Body ground
    Driver side door courtesy switch input
    Driver side door closed
    10 kΩ or higher
    Driver side door open
    Below 1 Ω
    PCTY (1D-24) - Body ground
    BR - Body ground
    Passenger side door courtesy switch input
    Passenger side door closed
    10 kΩ or higher
    Passenger side door open
    Below 1 Ω
    BCTY (1D-7) - Body ground
    R- Body ground
    Back door courtesy switch input
    Back door closed
    10 kΩ or higher
    Back door open
    Below 1 Ω
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the 1A, 1B, 1D, 1E and 1J junction block connectors.

  4. Measure the voltage of the connectors.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    HAZ (1L-17) - Body ground
    Y - Body ground
    Hazard warning light drive
    Answer-back OFF
    Below 1 V
    Answer-back ON
    Pulse generation
    RDA (B7-23) - Body ground
    W- Body ground
    Door control receiver input
    Transmitter switch OFF (power switch OFF and all door closed)
    Below 1 V
    Transmitter switch ON (power switch OFF and all door closed)
    Pulse generation
    If the result is not as specified, the junction block (ECU) have a malfunction.