DTC B1242 Wireless Door Lock Tuner Circuit Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1242 | Within 1 second after PRG signal is output from body ECU during self-diagnostic mode, corresponding RDA signal is not output. |
|

| 1.CHECK WIRE HARNESS (DOOR CONTROL RECEIVER - MAIN BODY ECU AND BODY GROUND) |
![]() |
Disconnect the D4 receiver connector.
Disconnect the B7 ECU connector.
Measure the resistance and voltage of the wire harness side connectors.
| Tester Connection | Specified Condition |
| D4-2 (RDA) - B7-23 (RDA) | Below 1 Ω |
| D4-3 (PRG) - B7-24 (PRG) | |
| D4-1 (GND) - Body ground | |
| D4-2 (RDA) or B7-23 (RDA) - Body ground | 10 kΩ or higher |
| D4-3 (PRG) or B7-24 (PRG) - Body ground |
|
| ||||
| OK | |
| 2.CHECK DOOR CONTROL RECEIVER (OPERATION) |
Temporarily replace the door control receiver with a new or normally functioning one.
Check that no DTC is output.
|
| ||||
| OK | ||
| ||