Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Smart Key System)

WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Smart Key System) > No Answer-Back

for Preparation Click here


DESCRIPTION

In some cases, wireless door lock control functions are normal but hazard warning light answer-back is not. In such case, the multiplex network body ECU's hazard warning light signal outputs may be malfunctioning.

NOTICE:
Troubleshooting should be started after confirming that the answer-back function has been switched ON.


INSPECTION PROCEDURE

1.CHECK WIRELESS DOOR LOCK CONTROL FUNCTION
  1. Check the wireless door lock control functions by operating the transmitter switch.

    Result: 
    Result
    Proceed to
    Wireless door lock control functions are normal but hazard warning light answer-back does not occur
    A
    Doors cannot be locked and unlocked with transmitter
    B



B
GO TO PROBLEM SYMPTOMS TABLE
A


2.PERFORM ACTIVE TEST BY TECHSTREAM (TURN SIGNAL FLASHER RELAY)
  1. Select ACTIVE TEST, use the Techstream to generate a control command, and then check that the hazard waning light flash.

    Main body ECU: 
    Item
    Test Detail
    Diagnostic Note
    Hazard
    Turn signal flasher relay ON / OFF
    -

    OK:
    Turn signal flasher relay turns ON / OFF.



OK
REPLACE DRIVER SIDE JUNCTION BLOCK ASSEMBLY (MAIN BODY ECU)
NG


3.CHECK HAZARD WARNING LIGHT
  1. Check that the hazard warning lights flash continuously when the hazard warning signal switch is pressed.

    OK:
    Hazard warning lights flash continuously.



NG
GO TO LIGHTING SYSTEM
OK

REPLACE DRIVER SIDE JUNCTION BLOCK ASSEMBLY (MAIN BODY ECU)