Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Smart Key System)

WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Smart Key System) > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST

HINT:
Using the Techstream's DATA LIST allows switch, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.

  1. Connect the Techstream (with CAN VIM) to the DLC3.

  2. Turn the power switch ON (IG).

  3. Read the DATA LIST.

    Main body ECU: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    D Door Courtesy SW
    Driver side door courtesy switch signal / ON or OFF
    ON: Driver side door is open
    OFF: Driver side door is closed
    -
    P Door Courtesy SW
    Passenger side door courtesy switch signal / ON or OFF
    ON: Passenger side door is open
    OFF: Passenger side door is closed
    -
    Rear Door Courtesy SW
    Rear door courtesy switch signal / ON or OFF
    ON: Either right or left door is open
    OFF: Both right and left doors are closed
    -
    D-Door Lock Pos SW
    Driver side door lock position switch signal / ON or OFF
    ON: Driver side door lock is in unlock position
    OFF: Driver side door lock is in lock position
    -
    Passenger Lock Pos SW
    Passenger side door lock position switch signal / ON or OFF
    ON: Passenger side door lock is in unlock position
    OFF: Passenger side door lock is in lock position
    -
    Rear Lock Position SW
    Rear door lock position switch signal / ON or OFF
    ON: Rear door lock is in unlock position
    OFF: Rear door lock is in lock position
    -

    Transponder key ECU: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Key SW
    Halfway switch signal / ON or OFF
    ON: Key is in key slot.
    OFF: No key is in key slot.
    -


PERFORM ACTIVE TEST

HINT:
Performing the Techstream's ACTIVE TEST allows relay, VSV, actuator, and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time. The DATA LIST can be displayed during the ACTIVE TEST.

  1. Connect the Techstream (with CAN VIM) to the DLC3.

  2. Turn the power switch ON (IG).

  3. Perform the ACTIVE TEST according to the display on the tester.

    Main body ECU: 
    Tester Display
    Test Part
    Control Range
    Hazard
    Turns turn signal flasher relay ON / OFF
    -
    Trunk and Back-Door Open
    Operate back door motor ON / OFF
    -
    Door Lock
    Operate door lock motor for all doors OFF / LOCK / UNLOCK
    All doors are closed