Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM

REAR VIEW MONITOR SYSTEM > Reverse Signal Circuit

for Preparation Click here


DESCRIPTION

The multi-display receives a reverse signal from the BK/UP LP relay (engine room relay block).

WIRING DIAGRAM


E126421E04


INSPECTION PROCEDURE

1.CHECK BACK-UP LIGHT
  1. Move the shift lever to the R position and check if the back-up light comes on.

    OK:
    The back-up light comes on.



NG
GO TO LIGHTING SYSTEM
OK


2.CHECK VEHICLE SIGNAL (DISPLAY CHECK MODE)


    E119736
  1. Enter the "Display Check" mode (Vehicle Signal Check Mode) (Click here).

  1. Check that the display changes between ON and OFF according to the shift lever operation (P and R).

    OK:
    Shift Lever Position
    Display
    R
    ON
    Except R
    OFF

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual change in the switch.



OK
PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE
NG


3.CHECK MULTI-DISPLAY


    E126484E02
  1. Disconnect the M13 display connector.

  1. Measure the voltage of the display.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    M13-21 (REV) - Body ground
    Power switch is ON (IG).
    Shift lever is moved to R position.
    10 to 14 V
    M13-21 (REV) - Body ground
    Power switch is ON (IG).
    Shift lever is moved to any position except R.
    Below 1 V



OK
REPLACE MULTI DISPLAY ASSEMBLY
NG

REPAIR OR REPLACE HARNESS OR CONNECTOR (MULTI-DISPLAY - ENGINE ROOM RELAY BLOCK (BK/UP LP RELAY))