Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM

AIR CONDITIONING SYSTEM > Heater Water Pump Circuit

for Preparation Click here


DESCRIPTION

The heater water pump sends engine coolant to the heater core while the engine is stopped to prevent heater effectiveness from becoming low.
Directed by the air conditioning amplifier, hybrid control ECU operates the water pump relay and drives the heater water pump.

WIRING DIAGRAM


E125221E01


INSPECTION PROCEDURE

1.INSPECT INTEGRATION RELAY (UNIT C: AC W/P)
I041202E01
  1. Remove the integration relay from the engine room junction block.

    NOTICE:
    As the integration relay is connected to the relays and fuses in the other systems, remove it with the power switch OFF. (A DTC may be output if the power switch is ON (IG).

  1. Measure the resistance of the relay.

    Standard resistance:
    Terminal No.
    Specified Condition
    3H-4 - 3H-5
    10 kΩ or higher
    3H-4 - 3H-5
    Below 1 Ω
    (When battery voltage applied to terminals 3H-5 and 3H-3)



NG
REPLACE INTEGRATION RELAY
OK


2.CHECK WIRE HARNESS (HYBRID CONTROL ECU - BATTERY)
E127523E01
  1. Install the integration relay.

  1. Disconnect the H16 ECU connectors.
    Measure the voltage of the wire harness side connector.

Standard voltage:
Tester Connection
Condition
Specified Condition
H16-5 (WP) - Body ground
Power switch ON (IG)
10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.CHECK HYBRID CONTROL ECU (WP VOLTAGE)
I036410E02
  1. Measure the voltage of the connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    H16-5 (WP) - Body ground
    Heater water pump not operated
    10 to 14 V
    H16-5 (WP) - Body ground
    Heater water pump operated
    Below 1 V



NG
REPLACE HYBRID CONTROL ECU
OK


4.INSPECT HEATER WATER PUMP ASSEMBLY
I036418E01
  1. Remove the heater water pump.

  1. Connect positive (+) lead to terminal 1 of the heater water pump connector and negative (-) lead to terminal 2.

    OK:
    Heater water pump operates smoothly.

    NOTICE:
    Complete operation within 10 seconds if there is no water in the heater water pump.



NG
REPLACE HEATER WATER PUMP ASSEMBLY
OK

REPAIR OR REPLACE HARNESS AND CONNECTOR