Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM

DTC    B1421    Solar Sensor Circuit (Passenger Side)

for Preparation Click here


DESCRIPTION

E109314E08
The solar sensor is installed in the upper part of the instrument panel to detect the amount of solar radiation with a photodiode to control the heater and air conditioner "AUTO" function. It sends appropriate signals to the air conditioning amplifier. The output voltage of the solar sensor changes in accordance with the amount of solar radiation. As the amount increases, the voltage increases. As the amount decreases, the voltage decreases. The air conditioning amplifier reads voltage output from the solar sensor.

DTC No.
Detection Condition
Trouble Area
B1421
Open or short in solar sensor circuit circuit.
(If the check is performed in a dark place, DTC B1421 may be displayed.)
  1. Solar sensor
  2. Wire harness between solar sensor and air conditioning amplifier or body ECU
  3. Air conditioning amplifier

WIRING DIAGRAM


E125208E01


INSPECTION PROCEDURE

1.READ VALUE OF TECHSTREAM
  1. Connect Techstream to DLC3.

  1. Turn the power switch ON (IG) and turn Techstream ON.

  1. Select the item below in the Data List, and read the display on Techstream.

    Air conditioning amplifier 
    Item
    Measurement Item / Display (Range)
    Normal Condition
    Diagnostic Note
    Solar Sensor (D side)
    Solar sensor (Driver side) /
    min.: 0 max.: 255
    Increases as brightness increases
    Open in the circuit: 0
    Short in the circuit: 255

    OK:
    The display is as specified in the normal condition.


    Result 
    Result
    Proceed to
    NG
    A
    OK (Checking from the PROBLEM SYMPTOMS TABLE)
    B
    OK (Checking from the DTC)
    C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

C
REPLACE AIR CONDITIONING AMPLIFIER
A


2.CHECK AIR CONDITIONING AMPLIFIER (TS VOLTAGE)
I041186E14
  1. Remove the air conditioning amplifier with connectors still connected.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A7-12 (S5TS) - A7-21 (TS)
    Power switch ON (IG)
    0.8 to 4.3 V

    HINT:
    1. As the inspection light is moved away from the sensor, the voltage increases.
    2. As the inspection light is moved closer to the sensor, the voltage decreases.
    3. Use an incandescent light for inspection. Bring it within 30 cm (11.8 in.) of the solar sensor.

    Result 
    Result
    Proceed to
    NG
    A
    OK (Checking from the PROBLEM SYMPTOMS TABLE)
    B
    OK (Checking from the DTC)
    C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

C
REPLACE AIR CONDITIONING AMPLIFIER
A


3.INSPECT SOLAR SENSOR
E072857E04
  1. Remove the solar sensor.

  1. Measure the resistance of the sensor.

    1. Connect the ohmmeter's positive (+) lead to terminal 2 and negative (-) lead to terminal 1 of the solar sensor.

    Standard resistance:
    Tester Connection
    Condition
    Specified condition
    1 - 2
    Sensor is subject to electric light
    Except ∞ Ω
    1 - 2
    Sensor is covered with a cloth
    ∞ Ω (No continuity)

    NOTICE:
    The connection procedure for using a digital tester such as an TOYOTA electrical tester is shown above. When using an analog tester, connect the positive (+) lead to terminal 1 and negative (-) lead to terminal 2 of the solar sensor.

    HINT:
    1. As the inspection light is moved away from the sensor, the resistance increases.
    2. Use an incandescent light for inspection. Bring it within 30 cm (11.8 in.) of the solar sensor.



NG
REPLACE SOLAR SENSOR
OK


4.CHECK WIRE HARNESS (SOLAR SENSOR - AIR CONDITIONING AMPLIFIER)
E125231E02
  1. Disconnect the A10 solar sensor connector.

  1. Disconnect the A7 amplifier connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    A7-12 (S5TS) - A10-1
    Below 1 Ω
    A7-21 (TS) - A10-2
    Below 1 Ω
    A7-12 (S5TS) - Body ground
    10 kΩ or higher
    A7-21 (TS) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER