Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM

DTC    B1473    A/C Inverter Start-up Signal System Malfunction

for Preparation Click here


DESCRIPTION

The inverter activation signal is sent to the A/C inverter from the hybrid control ECU. Compressor control is stopped and the DTC is output if there is an open or short in the signal circuit.

DTC No.
Detection Condition
Trouble Area
B1473
Open or short in A/C inverter start-up signal system
  1. Wire harness between hybrid control ECU and A/C inverter (inverter with converter)
  2. A/C inverter (inverter with converter)
  3. Hybrid control ECU

NOTICE:
The A/C inverter is integrated with the inverter with converter. It is necessary to replace the PCU box if the A/C inverter (inverter with converter) needs to be replaced because the A/C inverter (inverter with converter) cannot be replaced alone.


WIRING DIAGRAM


E125214E01


INSPECTION PROCEDURE

1.CHECK DIAGNOSTIC TROUBLE CODE
  1. Check if DTCs for the hybrid control system are output using Techstream.

    OK:
    DTCs are not output in the hybrid control system.



NG
GO TO HYBRID CONTROL SYSTEM
OK


2.CHECK WIRE HARNESS (HYBRID CONTROL ECU - A/C INVERTER)
E127536E02
  1. Disconnect the H15 ECU connector.

  1. Disconnect the I11 inverter connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    H15-25 (STB) - I11-5 (STB)
    0.5 to 0.8 Ω
    H15-25 (STB) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE A/C INVERTER