DTC B1498 Communication Malfunction (A/C Inverter Local) |
| DTC No. | Detection Condition | Trouble Area |
| B1498 | Communication line error or open between the hybrid control ECU and the A/C inverter (inverter with converter) |
|

| 1.CHECK WIRE HARNESS (HYBRID CONTROL ECU - INVERTER WITH CONVERTER) |
![]() |
Disconnect the H15 and H16 ECU connectors.
Disconnect the I11 inverter connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| H15-24 (ETI) - I11-3 (TOINV) | Below 1 Ω |
| H16-14 (ITE) - I11-2 (TOECU) | Below 1 Ω |
| H16-17 (CLK) - I11-4 (CLK) | Below 1 Ω |
| H15-24 (ETI) - Body ground | 10 kΩ or higher |
| H16-14 (ITE) - Body ground | 10 kΩ or higher |
| H16-17 (CLK) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK DIAGNOSTIC TROUBLE CODE |
Connect the H15 and H16 ECU connectors.
Connect the I11 inverter connector.
Check if DTCs for the hybrid control system are output using Techstream.
|
| ||||
| OK | ||
| ||