Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Display Signal Circuit between Navigation ECU and Multi-display

for Preparation Click here


DESCRIPTION

This is the display signal circuit from the navigation ECU to the multi-display.

WIRING DIAGRAM


I102036E01


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (NAVIGATION ECU - MULTI-DISPLAY)


    E128289E06
  1. Disconnect the N8 ECU connector.

  1. Disconnect the M16 display connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    N8-1 - M16-1
    Below 1 Ω
    N8-2 - M16-2
    Below 1 Ω
    N8-3 - M16-3
    Below 1 Ω
    N8-1 - Body ground
    10 kΩ or higher
    N8-2 - Body ground
    10 kΩ or higher
    N8-3 - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE