Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

DTC    5C-40    Camera Picture Error

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
5C-40
Synchronous signal from the camera cannot be transmitted.
  1. Wire harness
  2. Television camera
  3. Multi-display

WIRING DIAGRAM


E160119E01


INSPECTION PROCEDURE

HINT:
After the inspection is completed, clear the DTCs.

1.CHECK WIRE HARNESS (MULTI-DISPLAY - TELEVISION CAMERA)


    E126424E04
  1. Disconnect the M14 display connector.

  1. Disconnect the T13 camera connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    T13-4 (CB+) - M14-29 (CA+)
    Below 1 Ω
    T13-3 (CGND) - M14-30 (CGND)
    Below 1 Ω
    T13-2 (CV+) - M14-27 (V+)
    Below 1 Ω
    T13-1 (CV-) - M14-28 (V-)
    Below 1 Ω
    T13-4 (CB+) - Body ground
    10 kΩ or higher
    T13-3 (CGND) - Body ground
    10 kΩ or higher
    T13-2 (CV+) - Body ground
    10 kΩ or higher
    T13-1 (CV-) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2.CHECK MULTI-DISPLAY (CA+ VOLTAGE)


    E126425E01
  1. Measure the voltage of the display.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    M14-29 (CA+) - M14-30 (CGND)
    Power switch ON (IG), shift lever R position
    Approx. 6 V



NG
REPLACE MULTI-DISPLAY
OK

REPLACE TELEVISION CAMERA ASSEMBLY