Home › SUSPENSION & AXLE › SUSPENSION › FRONT SHOCK ABSORBER WITH COIL SPRING

FRONT SHOCK ABSORBER WITH COIL SPRING > DISPOSAL

for Preparation Click here


HINT:
Dispose of the RH side following the same procedures as the LH side.



1. DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY LH


    F047347E01
  1. Fully extend the shock absorber rod.

  1. Using a drill, make a hole in the cylinder between A and B shown in the illustration to discharge the gas inside.

    CAUTION:
    Be careful when drilling because shards of metal may fly about, so always use the proper safety equipment.

    NOTICE:
    The gas is colorless, odorless and non-poisonous.