Home › SUSPENSION & AXLE › SUSPENSION › FRONT SHOCK ABSORBER WITH COIL SPRING

FRONT SHOCK ABSORBER WITH COIL SPRING > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT WHEEL


2. REMOVE FRONT WIPER ARM HEAD CAP


3. REMOVE FRONT WIPER ARM LH
  1. Remove the 2 nuts and FR wiper arm LH.



4. REMOVE FRONT WIPER ARM RH
  1. Remove the nut and FR wiper arm RH.



5. REMOVE HOOD TO COWL TOP SEAL


    I038368E02
  1. Detach the 8 clips and remove the hood to cowl top seal.



6. REMOVE COWL TOP VENTILATOR LOUVER LH


    I038369E02
  1. Detach the 8 claws and clip, and remove the cowl top ventilator louver LH.



7. REMOVE COWL TOP VENTILATOR LOUVER RH


    I038370E02
  1. Detach the 8 claws and clip, and remove the cowl top ventilator louver RH.



8. REMOVE WINDSHIELD WIPER MOTOR AND LINK


    I038371E01
  1. Disconnect the connector.

  1. Remove the 5 bolts and wiper motor & link.



9. DISCONNECT FRONT STABILIZER LINK ASSEMBLY


    F046088E01
  1. Place a wooden block on a jack, and support the front suspension lower No. 1 arm with the jack.

  1. Remove the nut and separate the front stabilizer link from the shock absorber with coil spring.

    HINT:
    Use a 6 mm hexagon wrench to hold the stud if the ball joint turns together with the nut.



10. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING


    C080880E01
  1. Remove the bolt and disconnect the front flexible hose No. 1 and speed sensor front LH wire harness.

    NOTICE:
    Be sure to completely disconnect the speed sensor front LH from the front shock absorber.



    F046086E01
  1. Remove the 2 nuts on the lower side of the front shock absorber with coil spring.

    NOTICE:
    Keep the bolts inserted.



    F046083E01
  1. Remove the 3 nuts.

  1. Lower the jack slowly. Remove the 2 bolts on the lower side and the front shock absorber with coil spring.

    NOTICE:
    Ensure that the speed sensor front LH is completely disconnected from the front shock absorber with coil spring.