Home › SUSPENSION & AXLE › SUSPENSION › FRONT SHOCK ABSORBER WITH COIL SPRING

FRONT SHOCK ABSORBER WITH COIL SPRING > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT SHOCK ABSORBER ASSEMBLY LH


2. INSTALL FRONT COIL SPRING INSULATOR LOWER LH


    F047342E01
  1. Install the front coil spring insulator lower to the front shock absorber so that both recessed parts are aligned.



3. INSTALL FRONT SPRING BUMPER LH


4. INSTALL FRONT COIL SPRING LH


    F047343E01
  1. Using SST, compress the coil spring.

    SST
    09727-30021   (09727-00010, 09727-00021, 09727-00031)

    NOTICE:
    Do not use an impact wrench. It will damage SST.

    HINT:
    The coil spring can also be installed/removed using the hydraulic spring compressor.

  1. Fit the lower end of the front coil spring LH into the recessed part of the spring lower seat.

    HINT:
    Install the spring with the smaller diameter on top.



5. INSTALL FRONT COIL SPRING INSULATOR UPPER LH


    F047344E01
  1. Install the front coil spring insulator upper to the front shock absorber with the protruding part facing the outside of the vehicle.



6. INSTALL FRONT COIL SPRING SEAT UPPER LH


    F047346E01
  1. Install the front coil spring seat upper with the recess facing the outside of the vehicle.

    NOTICE:
    1. Fit the protruding part of the front coil spring insulator upper LH to the recess of the front coil spring seat upper LH.
    2. Ensure that the width across the flat parts of the piston rod and the front coil spring seat upper LH are fitted.



7. INSTALL FRONT SUSPENSION SUPPORT LH DUST SEAL


8. INSTALL FRONT SUSPENSION SUPPORT SUB-ASSEMBLY LH


9. INSTALL FRONT SUPPORT TO FRONT SHOCK ABSORBER LH NUT


    F047341E01
  1. Secure the front coil spring seat upper with SST and tighten it with a new nut.

    Torque:
    47 N*m{ 479 kgf*cm , 35 ft.*lbf }

  1. Release SST while aligning the protruding part of the front coil spring insulator upper, the recess of the spring front coil spring seat upper and the shock absorber lower bracket, and then remove SST from the coil spring.

    SST
    09729-22031  

    NOTICE:
    Do not use an impact wrench when removing SST.



    F047345E01
  1. Apply No. 2 MP grease to the parts indicated in the illustration and install the front suspension support dust cover.