Home › SUSPENSION & AXLE › SUSPENSION › FRONT STABILIZER BAR

FRONT STABILIZER BAR > INSPECTION

for Preparation Click here



1. INSPECT FRONT STABILIZER LINK ASSEMBLY


    C066721E01
  1. Flip the ball joint stud back and forth 5 times as shown in the illustration before installing the nut.

  1. Use a torque wrench to turn the nut continuously at a rate of 2 to 4 seconds per turn. Take the torque reading on the fifth turn.

    Torque:
    0.05 to 1.96 N*m{ 0.5 to 20 kgf*cm , 0.4 to 17.4 in.*lbf }

  1. Check the dust cover for cracks or grease leakage.
    If the value is not within the specified range, replace the front stabilizer link with a new one.