Home › SUSPENSION & AXLE › SUSPENSION › REAR SHOCK ABSORBER WITH COIL SPRING

REAR SHOCK ABSORBER WITH COIL SPRING > DISPOSAL

for Preparation Click here



1. DISPOSE OF REAR SHOCK ABSORBER ASSEMBLY LH


    F045732E01
  1. Fully extend the shock absorber rod.

  1. Make a hole in the cylinder somewhere between A and B shown in the illustration to discharge the gas inside using a drill.

    CAUTION:
    Be careful when drilling because shards of metal may fly about, so always use the proper safety equipment.

    NOTICE:
    The gas is colorless, odorless and non-poisonous.