Home › SUSPENSION & AXLE › SUSPENSION › REAR SHOCK ABSORBER WITH COIL SPRING

REAR SHOCK ABSORBER WITH COIL SPRING > REMOVAL

for Preparation Click here



1. REMOVE REAR NO. 2 FLOOR BOARD


2. REMOVE REAR DECK FLOOR BOX


3. REMOVE REAR DECK TRIM COVER


    B076395E02
  1. Using a screwdriver, detach the 4 claws and remove the trim cover.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE TONNEAU COVER ASSEMBLY


5. REMOVE REAR SEATBACK ASSEMBLY LH
  1. Open the front part of the rear No. 1 floor deck board.

  1. Tilt the seatback down toward the front of the vehicle.



    B076029E01
  1. Remove the 2 bolts and seatback.



6. REMOVE REAR NO. 1 FLOOR BOARD


    B132619E01
  1. Remove the 2 bolts and the 2 rope hooks.

  1. Using a clip remover, remove the 2 clips.

  1. Using a screwdriver, detach the 5 clips and remove the floor board.

    HINT:
    Tape the screwdriver tip before use.



7. REMOVE REAR SIDE SEATBACK FRAME LH


    B076393E02
  1. Remove the bolt.

  1. Detach the claw and remove the frame.



8. REMOVE REAR NO. 4 FLOOR BOARD


9. REMOVE DECK FLOOR BOX LH


10. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH


    B073591E02
  1. Remove the screw and 2 bolts.

  1. Using a clip remover, remove the clip.

  1. Using a screwdriver, detach the 7 claws and 3 clips, and remove the side panel.

    HINT:
    Tape the screwdriver tip before use.



11. REMOVE BATTERY CARRIER BRACKET


    A083527E01
  1. Remove the 7 bolts and battery carrier bracket.



12. REMOVE REAR WHEEL


13. REMOVE REAR SHOCK ABSORBER WITH COIL SPRING


    F040125E02
  1. Support the rear axle beam with a jack. Insert a wooden block between the jack and the rear axle beam to prevent damage.



    G027360E01
  1. Remove the 2 nuts from the rear shock absorber with coil spring (upper side).

  1. Remove the rear shock absorber with coil spring (upper side) bolt from the under-side of the vehicle.



    C067565E01
  1. Remove the nut and spacer from the rear shock absorber with coil spring (lower side).

  1. Remove the rear shock absorber with coil spring while slowly lowering the jack.

    NOTICE:
    Seat the jack so that no extra load is placed on the shock absorber on the opposite side of the vehicle.