Home › SUSPENSION & AXLE › SUSPENSION › REAR SHOCK ABSORBER WITH COIL SPRING

REAR SHOCK ABSORBER WITH COIL SPRING > DISASSEMBLY

for Preparation Click here



1. REMOVE REAR SHOCK ABSORBER ASSEMBLY LH


    F040127E01
  1. Use a 6 mm socket hexagon wrench to secure the piston rod of the shock absorber and loosen the nut.

    NOTICE:
    1. Do not remove the nut.
    2. Sufficiently insert the hexagon wrench.



    F040126E01
  1. Attach SST to the coil spring so that the upper and lower hooks of the installed area are as wide as possible.

    SST
    09727-30021   (09727-00010, 09727-00021, 09727-00031)

  1. Compress the coil spring until it moves freely.

    NOTICE:
    Do not use an impact wrench. It will damage SST.

  1. Remove the nut.



    F047405E01
  1. Remove the No. 1 cushion washer, No. 1 cushion, rear spring front bracket, rear suspension support, rear coil spring insulator upper and rear No. 1 spring bumper.

    HINT:
    The shock absorber can be replaced without removing the No. 1 cushion and rear suspension support from the rear spring front bracket.

  1. Release SST and remove it from the coil spring after removing the coil spring from the shock absorber.