Home › SUSPENSION & AXLE › SUSPENSION › REAR AXLE BEAM

REAR AXLE BEAM > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL


2. REMOVE FLOOR PANEL SIDE PLATE LH


    G027352E01
  1. Remove the 3 bolts and floor panel side plate.



3. REMOVE FLOOR PANEL SIDE PLATE RH
  1. Remove the 3 bolts and floor panel side plate.



4. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ HID Headlight System)


    G027356E01
  1. Remove the nut and height control sensor.



5. REMOVE REAR SENSOR CONNECTING BRACKET (w/ HID Headlight System)


    G027357E01
  1. Remove the 2 nuts and sensor connecting bracket.



6. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY


    F047456E01
  1. Put matchmarks on the rear brake drum and the axle hub.

  1. Release the parking brake and remove the rear brake drum.

    HINT:
    If the rear brake drum cannot be removed, push the rear brake automatic adjust lever through the backing plate service hole using a screwdriver. Turn and contract the adjuster using another screwdriver.



7. DISCONNECT SKID CONTROL SENSOR WIRE


    G027358E01
  1. Remove the 2 bolts and clip, and disconnect the skid control sensor wire and parking brake cable from the rear axle beam.

    NOTICE:
    1. Ensure no foreign matter is on the end of the skid control sensor wire.
    2. Ensure that the skid control sensor wire is disconnected from the rear axle beam.

    HINT:
    Use the same procedures for the RH side and LH side.



8. REMOVE REAR AXLE BEAM DAMPER
  1. Remove the rear axle beam damper from the rear axle beam.



9. REMOVE REAR STABILIZER BAR


    G027354E01
  1. Remove the 2 bolts, 2 nuts and stabilizer bar.



10. DISCONNECT REAR NO. 4 BRAKE TUBE


    C066801E01
  1. Using SST, disconnect the rear brake tube from the flexible hose.

    SST
    09023-00101  

    NOTICE:
    Do not damage the rear brake tube or flexible hose.

  1. Remove the clip.



11. DISCONNECT REAR NO. 3 BRAKE TUBE

HINT:
Use the same procedures as the rear No. 4 brake tube.



12. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH


    C066800E01
  1. Remove the 4 bolts. Remove the axle hub and bearing and parking brake plate from the rear axle beam.

    NOTICE:
    1. Do not twist the parking brake cable.
    2. Use rope, etc. to suspend the parking brake plate.



13. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY RH

HINT:
Use the same procedures for the RH side and LH side.



14. DISCONNECT REAR SHOCK ABSORBER WITH COIL SPRING


    C067565E01
  1. Remove the 2 nuts from the left and right sides.

  1. Disconnect the rear shock absorber with coil springs (lower side) from the rear axle beam.



15. REMOVE REAR AXLE BEAM ASSEMBLY


    C066806E01
  1. Support the rear axle beam with a jack. Insert a wooden block between the jack and the center of the rear axle beam to prevent damage.



    G028839E01
  1. Remove the 2 bolts and 2 nuts from the left and right sides.

    NOTICE:
    Keep the nut from rotating when removing the bolt.

  1. Remove the rear axle beam by slowly lowering the jack.

    NOTICE:
    Ensure that the skid control sensor wire is completely disconnected from the rear axle beam.