Home › SUSPENSION & AXLE › SUSPENSION › REAR AXLE BEAM

REAR AXLE BEAM > DISASSEMBLY

for Preparation Click here



1. REMOVE REAR AXLE CARRIER BUSH LH


    F047402E01
  1. Place a matchmark on the rear axle beam after aligning it with the bush recess.

  1. Make 2 bends in the rim of the bush using a chisel and hammer.

  1. Using SST, remove the bush from the rear axle beam.

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04030, 09954-04020, 09955-04051, 09957-04010, 09958-04011)
    09950-60010   (09951-00630)

    NOTICE:
    1. Do not erase the matchmark on the rear axle beam when removing the bush.
    2. Apply chassis black if the rear axle beam is scratched.



2. REMOVE REAR AXLE CARRIER BUSH RH

HINT:
Use the same procedures for the RH side and LH side.