Home › SUSPENSION & AXLE › SUSPENSION › REAR AXLE BEAM

REAR AXLE BEAM > REASSEMBLY

for Preparation Click here



1. INSTALL REAR AXLE CARRIER BUSH LH
  1. When replacing only the bush:

    1. Temporarily install a new bush recess by aligning it with the matchmark on the rear axle beam.

      NOTICE:
      Install the bush in the same direction as before it was removed.



    F047479E02
  1. When replacing the rear axle beam:

    1. Temporarily install a new bush as shown in the illustration.



    F047404E01
  1. Using SST, install the bush to the rear axle beam.

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04030, 09954-04020, 09955-04051, 09957-04010, 09958-04011)
    09950-60010   (09951-00620)
    09710-04101  

    NOTICE:
    1. Hang the claw of SST to the bush firmly.
    2. Do not damage the rubber sections indicated by the arrow in the illustration when installing the bush.



2. INSTALL REAR AXLE CARRIER BUSH RH

HINT:
Use the same procedures for the RH side and LH side.