Home › BRAKE › BRAKE › FRONT BRAKE

FRONT BRAKE > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.
  3. If work that does not involve brake fluid bleeding, such as disc brake pad replacement, is started 2 minutes or more after the power switch is turned OFF, brake control (Electronically Controlled Brake system) prohibition is not necessary.



1. REMOVE FRONT WHEEL


2. SET BRAKE CONTROL OFF


F046145E01

NOTICE:
Prohibit the brake control (Electronically Controlled Brake system) before bleeding the brake fluid.

  1. With the power switch OFF to prohibit brake control, remove the No. 1 and No. 2 motor relays.

    NOTICE:
    If the pump motor operates while there is air remaining inside the brake actuator hose, the air will enter the actuator, resulting in difficulty in air bleeding.

    HINT:
    Brake control (Electronically Controlled Brake system) can be prohibited by selecting "ELECTRONICALLY CONTROLLED BRAKE SYSTEM INVALID" on the Techstream.



3. DRAIN BRAKE FLUID

NOTICE:
Wash brake fluid off immediately if it adheres to any painted surface.



4. REMOVE FRONT DISC BRAKE CYLINDER SUB-ASSEMBLY


    F046161E01
  1. Remove the union bolt and gasket, and disconnect the No. 1 flexible hose from the front disc brake cylinder.

  1. Hold the front disc brake cylinder slide pin using a wrench. Remove the 2 bolts and separate the front disc brake cylinder.



5. REMOVE FRONT DISC BRAKE PAD KIT (PAD ONLY)
  1. Remove the 2 front disc brake pads from the front disc brake cylinder mounting.



6. REMOVE FRONT ANTI-SQUEAL SHIM KIT
  1. Remove the 2 No. 1 anti-squeal shims and 2 No. 2 anti-squeal shims from the front disc brake pads.



7. REMOVE NO. 1 FRONT DISC BRAKE PAD SUPPORT PLATE
  1. Remove the No. 1 pad support plate from the front disc brake cylinder mounting.



8. REMOVE NO. 2 FRONT DISC BRAKE PAD SUPPORT PLATE
  1. Remove the No. 2 pad support plate from the front disc brake cylinder mounting.



9. REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN


    F046162E01
  1. Pull off the 2 front disc brake cylinder slide pins from the front disc brake cylinder mounting.



10. REMOVE FRONT DISC BRAKE BUSH DUST BOOT
  1. Remove the 2 bush dust boots from the front disc brake cylinder mounting.



11. REMOVE FRONT DISC BRAKE CYLINDER MOUNTING LH


    F046163E01
  1. Remove the 2 bolts and front disc brake cylinder mounting.