Home › BRAKE › BRAKE › FRONT BRAKE

FRONT BRAKE > DISASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. REMOVE CYLINDER BOOT


    F046164E01
  1. Remove the set ring and cylinder boot from the front disc brake cylinder.



2. REMOVE FRONT DISC BRAKE PISTON


    F101069E01
  1. Place a wooden block wrapped in a cloth between the front disc brake piston and front disc brake cylinder to prevent them from being damaged.

  1. Put air into the front disc brake cylinder gradually so that the piston does not protrude using compressed air. Remove the front disc brake piston from the front disc brake cylinder.

    CAUTION:
    Be careful not to pinch fingers.

    NOTICE:
    Do not spatter fluid.



3. REMOVE PISTON SEAL


    F101056
  1. Using a screwdriver, remove the piston seal from the front disc brake cylinder.

    NOTICE:
    Do not damage the inside of the cylinder or the seal groove.



4. REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP


5. REMOVE FRONT DISC BRAKE BLEEDER PLUG


6. REMOVE FRONT DISC


F101070E01

HINT:
Put matchmarks on the disc and axle hub.