Home › BRAKE › BRAKE › REAR DRUM BRAKE

REAR DRUM BRAKE > DISASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. DISCONNECT PARKING BRAKE SHOE STRUT SET LH


    F047457E02
  1. Using SST, disconnect the spring and parking brake shoe strut set from the brake shoes.

    SST
    09703-30011  

    NOTICE:
    Be careful not to damage the cylinder dust boot.



2. REMOVE FRONT BRAKE SHOE


    F101074E01
  1. Using SST, remove the cup, shoe hold down spring and pin.

    SST
    09718-00010  

  1. Remove the front brake shoe and tension spring.



3. REMOVE PARKING BRAKE SHOE STRUT SET LH
  1. Remove the parking brake shoe strut set from the rear brake shoe.



4. REMOVE REAR BRAKE AUTOMATIC ADJUST LEVER LH


    F101060
  1. Remove the rear brake automatic adjust lever tension spring and the rear brake automatic adjust lever.



5. REMOVE REAR BRAKE SHOE


    F047459E01
  1. Remove the tension spring from the rear brake shoe.

  1. Using SST, remove the cup, shoe hold down spring and pin.

    SST
    09718-00010  



    F101075
  1. Using needle-nose pliers, disconnect the parking brake cable, and remove the rear brake shoe.



6. REMOVE REAR BRAKE PARKING BRAKE SHOE LEVER SUB-ASSEMBLY


    F101061
  1. Using a screwdriver, remove the C-washer and parking brake shoe lever.



7. REMOVE FRONT OR UPPER REAR WHEEL BRAKE CYLINDER ASSEMBLY LH


    F101063
  1. Using SST, disconnect the brake line.

    SST
    09023-00101  

    HINT:
    Use a container to catch the brake fluid.

  1. Remove the bolt and the rear wheel brake cylinder.



8. REMOVE REAR WHEEL CYLINDER CUP KIT
  1. Remove the 2 cylinder dust boots from the rear wheel brake cylinder.

  1. Remove the 2 pistons and the compression spring.

  1. Remove the 2 wheel cylinder cups from each piston.



9. REMOVE REAR DRUM BRAKE BLEEDER PLUG
  1. Remove the rear drum bleeder plug from the rear wheel cylinder.