PARKING BRAKE SYSTEM > ADJUSTMENT |
| 1. REMOVE REAR WHEEL |
| 2. ADJUST PARKING BRAKE SHOE CLEARANCE |
![]() |
Temporarily install 2 hub nuts.
Remove the hole plug, and turn the adjuster to expand the shoe until the drum locks.
Rotate the adjuster by 8 notches.
Install the hole plug.
Remove the 2 hub nuts.
| 3. INSTALL REAR WHEEL |
| 4. CHECK PARKING BRAKE PEDAL TRAVEL |
Firmly depress the parking brake pedal.
Release the parking brake.
Slowly depress the parking brake pedal all the way again and count the number of clicks.
| 5. ADJUST PARKING BRAKE PEDAL TRAVEL |
Remove the rear console box (Click here).
Remove the front floor footrest .
Remove the 8 bolts and front floor crossmember reinforcement LH.
![]() |
Slide the cover to the rear of the vehicle as shown in the illustration.
![]() |
Depress the parking brake pedal 5 clicks. Hold the adjusting nut using a wrench and loosen the lock nut.
Release the parking brake.
Turn the lock nut and adjusting nut until parking brake travel is within the specified range.
Count the number of clicks after depressing and releasing the parking brake pedal 3 to 4 times.
Check whether the parking brake drags or not.
When operating the parking brake pedal, check that the parking brake pedal indicator light comes on.
![]() |
Return the cover to the original position as shown in the illustration.
Install the front floor crossmember reinforcement LH with the 8 bolts.
Install the front floor footrest .
Install the rear console box (Click here).