Home › BRAKE › BRAKE CONTROL › BRAKE ACTUATOR

BRAKE ACTUATOR > DISPOSAL

for Preparation Click here



1. DISPOSE OF BRAKE ACTUATOR ASSEMBLY


    F046643E06
  1. Using a drill, slowly make a hole at the radius indicated at the middle of A in the illustration and bleed the charged gas.

    CAUTION:
    Be sure to wear protective glasses as fragments may fly out due to pressure.

    HINT:
    1. The hole may be drilled up to approximately 5 to 10 mm (0.20 to 0.39 in.) away from the point indicated by A.
    2. The gas is nitrogen, which is colorless, odorless, and harmless.