Home › BRAKE › BRAKE CONTROL › STEERING ANGLE SENSOR

STEERING ANGLE SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE NO. 2 STEERING WHEEL COVER LOWER


3. REMOVE NO. 3 STEERING WHEEL COVER LOWER


4. REMOVE STEERING PAD ASSEMBLY


A125170E04
  1. Straighten the front wheels.

  1. Using a T30 "TORX" socket, loosen the 2 screws until the groove along each screw circumference catches on the screw case.



    H043738E02
  1. Pull out the steering pad from the steering wheel and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Using a screwdriver, disconnect the 2 airbag connectors.

    CAUTION:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Disconnect the horn connector and remove the steering pad.



5. REMOVE STEERING WHEEL ASSEMBLY


G028394E02
  1. Remove the nut and put matchmarks on the steering wheel and steering main shaft.

  1. Using SST, remove the steering wheel.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)



6. REMOVE TILT LEVER BRACKET


F046710E01
  1. Remove the 2 screws and tilt lever bracket.



7. REMOVE STEERING COLUMN COVER


F046711E01
  1. Detach the 4 claws and remove the 3 screws. Then remove the steering column lower cover and the steering column upper cover.



8. REMOVE SPIRAL CABLE SUB-ASSEMBLY


H043749E02
  1. Disconnect the airbag connector.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Detach the 3 claws and remove the spiral cable.



9. REMOVE STEERING ANGLE SENSOR


    F045898E03
  1. Detach the 6 claws and remove the sensor from the spiral cable.