Home › BODY ELECTRICAL › DOOR LOCK › REAR DOOR LOCK

REAR DOOR LOCK > INSPECTION

for Preparation Click here



1. INSPECT REAR DOOR LOCK LH


B079248E06
  1. Apply battery voltage to the door lock and check operation of the door lock motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) →Terminal 4
    Battery negative (-) →Terminal 1
    Lock
    Battery positive (+) →Terminal 1
    Battery negative (-) →Terminal 4
    Unlock

    If the result is not as specified, replace the door lock assembly.



    B079248E06
  1. Measure the resistance of the position switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    6 - 9
    Lock
    Below 1 Ω
    Unlock
    10 kΩ or higher

    If the result is not as specified, replace the door lock assembly.



2. INSPECT REAR DOOR LOCK RH


B079249E04
  1. Apply battery voltage to the door lock and check operation of the door lock motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) →Terminal 4
    Battery negative (-) →Terminal 1
    Lock
    Battery positive (+) →Terminal 1
    Battery negative (-) →Terminal 4
    Unlock

    If the result is not as specified, replace the door lock assembly.



    B079249E04
  1. Measure the resistance of the position switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    6 - 9
    Lock
    Below 1 Ω
    Unlock
    10 kΩ or higher

    If the result is not as specified, replace the door lock assembly.