Home › BODY ELECTRICAL › DOOR LOCK › BACK DOOR LOCK

BACK DOOR LOCK > INSPECTION

for Preparation Click here



1. INSPECT BACK DOOR OPENER SWITCH


B075486E01
  1. Measure the resistance of the switch

    Standard resistance:
    Tester Connection
    Switch Connection
    Specified Condition
    1 - 2
    Pushed (ON)
    Below 1 Ω
    Not pushed (OFF)
    10 kΩ or higher

    If the result is not as specified, replace the switch.



2. INSPECT BACK DOOR LOCK


B079562E01
  1. Apply battery voltage to the door lock and check operation the latch.

    Standard resistance:
    Measurement Condition
    Specified Condition
    Battery positive (+) →Terminal 4
    Battery negative (-) →Terminal 3
    Latch turns to open-latch position

    If the result is not as specified, replace the motor.



    B079558E01
  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    Switch Connection
    Specified Condition
    1 - 2
    Open-latch
    Below 1 Ω
    Half-latch
    Full-latch
    10 kΩ or higher
    Over-latch

    If the result is not as specified, replace the door lock assembly.