Home › ENGINE › 1NZ-FXE STARTING › POWER SWITCH

POWER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT POWER SWITCH


    B080049E04
  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    7 (SS2) - 6 (GND)
    Pushed
    Below 1 Ω
    5 (SS1) - 6 (GND)
    Pushed
    Below 1 Ω
    7 (SS2) - 6 (GND)
    Released
    10 kΩ or higher
    5 (SS1) - 6 (GND)
    Released
    10 kΩ or higher

    If the resistance is not as specified, replace the power switch.