POWER WINDOW CONTROL SYSTEM > Manual Up / Down Function does not Operate on Driver Side |

| 1.CHECK POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (BW, BDR VOLTAGE) |
![]() |
Disconnect the P17 switch connector.
Measure the voltage of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
| P17-7 (BW) - P17-1 (E) | Always | 10 to 14 V |
| P17-11 (BDR) - P17-1 (E) | Power switch ON (IG) | 10 to 14 V |
|
| ||||
| OK | |
| 2.CHECK POWER WINDOW REGULATOR MOTOR ASSEMBLY FRONT LH |
![]() |
Disconnect the P17 switch connector.
Using a service wire, connect the terminals according to the table below.
Check operation of the power window regulator motor.
| Wire Connection | Specified Condition |
| P17-4 (DU) - P17-7 (BW) P17-9 (DD) - Body ground | Power window moves UP |
| P17-4 (DU) - Body ground P17-7 (BW) - P17-9 (DD) | Power window moves DOWN |
|
| ||||
| NG | |
| 3.CHECK WIRE HARNESS (MASTER SWITCH - REGULATOR MOTOR) |
![]() |
Disconnect the P17 switch connector.
Disconnect the P18 motor connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| P17-9 (DD) - P18-1 (D) | Below 1 Ω |
| P17-4 (DU) - P18-2 (U) | Below 1 Ω |
| P17-9 (DD) or P18-1 (D) - Body ground | 10 kΩ or higher |
| P17-4 (DU) or P18-2 (U) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||