Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM

POWER WINDOW CONTROL SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



CHECK DLC3
H100769E16

HINT:
The vehicle uses the ISO 15765-4 communication protocol. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format.


Symbols (Terminal No.)
Terminal Description
Condition
Specified Condition
SIL (7) - SG (5)
Bus '+' line
During transmission
Pulse generation
CG (4) - Body ground
Chassis ground
Always
Below 1 Ω
SG (5) - Body ground
Signal ground
Always
Below 1 Ω
BAT (16) - Body ground
Battery positive
Always
10 to 14 V
CANH (6) - CANL (14)
HIGH-level CAN bus line
Power switch OFF*
54 to 69 Ω
CANH (6) - CG (4)
HIGH-level CAN bus line
Power switch OFF*
1 kΩ or more
CANL (14) - CG(4)
HIGH-level CAN bus line
Power switch OFF*
1 kΩ or more
CANH (6) - BAT (16)
LOW-level CAN bus line
Power switch OFF*
1 kΩ or more
CANL (14) - BAT (16)
LOW-level CAN bus line
Power switch OFF*
1 kΩ or more

NOTICE:
*: Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the power switch, any other switches or the doors.

  1. If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.

HINT:
Connect the cable of the Techstream to the DLC3, turn the power switch ON (IG) and attempt to use the Techstream. If the display informs that a communication error has occurred, there is a problem either with the vehicle or with the tester.
  1. If communication is normal when the tester is connected to another vehicle, inspect the DLC3 of the original vehicle.
  2. If communication is still impossible when the tester is connected to another vehicle, the problem is probably in the tester itself. Consult the Service Department listed in the tester's instruction manual.


INSPECT BATTERY VOLTAGE
If the voltage is below 11 V, replace the battery before proceeding.

Standard:
11 to 14 V