POWER WINDOW CONTROL SYSTEM > INITIALIZATION |
| RESET (INITIALIZE) POWER WINDOW REGULATOR MOTOR (for Driver Side) |
*1: Turn the power switch ON (IG).
*2: Open the power window halfway by pressing the power window switch.
*3: Fully pull up on the switch until the power window is fully closed and continue to hold the switch for at least 1 second.
*4: Check that the AUTO UP / DOWN function operates normally.
If the AUTO UP / DOWN function operates normally, reset operations are complete. If abnormal, follow steps below.
Disconnect the negative (-) battery terminal cable for 10 seconds.
Connect the battery terminal cable.
Perform steps *1 to *4 again.