POWER WINDOW CONTROL SYSTEM > Manual Up / Down Function does not Operate on Rear LH Only |

| 1.CHECK POWER WINDOW REGULATOR SWITCH ASSEMBLY REAR LH (POWER SOURCE VOLTAGE) |
![]() |
Disconnect the P15 switch connector.
Measure the voltage of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
| P15-4 - Body ground | Power switch ON (IG) | 10 to 14 V |
|
| ||||
| OK | |
| 2.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY REAR LH |
Check the regulator switch (Click here).
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (REGULATOR SWITCH - REGULATOR MOTOR) |
![]() |
Disconnect the P15 switch connector.
Disconnect the P20 motor connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| P15-1 - P20-1 | Below 1 Ω |
| P15-3 - P20-2 | Below 1 Ω |
| P15-1 or P20-1 - Body ground | 10 kΩ or higher |
| P15-3 or P20-2 - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY REAR LH |
Check the regulator motor (Click here).
|
| ||||
| OK | |
| 5.CHECK WIRE HARNESS (MASTER SWITCH - REGULATOR SWITCH) |
![]() |
Disconnect the P17 switch connector.
Disconnect the P15 switch connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| P17-12 (RLU) - P15-5 | Below 1 Ω |
| P17-10 (RLD) - P15-2 | Below 1 Ω |
| P17-12 (RLU) or P15-5 - Body ground | 10 kΩ or higher |
| P17-10 (RLD) or P15-2 - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||