POWER WINDOW CONTROL SYSTEM > Manual Up / Down Function does not Operate on Rear RH Only |

| 1.CHECK POWER WINDOW REGULATOR SWITCH ASSEMBLY REAR RH (POWER SOURCE VOLTAGE) |
![]() |
Disconnect the P16 switch connector.
Measure the voltage of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
| P16-4 - Body ground | Power switch ON (IG) | 10 to 14 V |
|
| ||||
| OK | |
| 2.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY REAR RH |
Check the regulator switch (Click here).
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (REGULATOR SWITCH - REGULATOR MOTOR) |
![]() |
Disconnect the P16 switch connector.
Disconnect the P21 motor connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| P16-1 - P21-1 | Below 1 Ω |
| P16-3 - P21-2 | Below 1 Ω |
| P16-1 or P21-1 - Body ground | 10 kΩ or higher |
| P16-3 or P21-2 - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY REAR RH |
Check the regulator motor (Click here).
|
| ||||
| OK | |
| 5.CHECK WIRE HARNESS (REGULATOR MASTER SWITCH - REGULATOR SWITCH) |
![]() |
Disconnect the P17 switch connector.
Disconnect the P16 switch connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| P17-18 (RRU) - P16-5 | Below 1 Ω |
| P17-16 (RRD) - P16-2 | Below 1 Ω |
| P17-18 (RRU) or P16-5 - Body ground | 10 kΩ or higher |
| P17-16 (RRD) or P16-2 - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||