Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT ASSEMBLY

HEADLIGHT ASSEMBLY > REMOVAL

for Preparation Click here


  1. Use the same procedures for the RH and LH sides.
  2. The procedures listed below are for the LH side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE FRONT FENDER LINER LH


    B130315
  1. Using a clip remover, remove the clip.

  1. Partially remove the fender liner.

    HINT:
    It is not necessary to fully remove the fender liner. Partially remove it so that the bumper cover can be removed in a later step.



3. REMOVE FRONT FENDER LINER RH

HINT:
Use the same procedure described for the LH side.



4. REMOVE FRONT BUMPER COVER


B130316E01
  1. Put protective tape under the front fender.

  1. Using a clip remover, remove the 3 clips.

  1. Remove the 2 radiator grille protectors and 4 screws.

  1. Detach the 8 claws.



    B078079E02
  1. Detach the 4 claws and remove the bumper cover.

    1. Hold the front bumper cover on its upper and lower parts with your hands as shown in the illustration.

    2. Pull up the front bumper cover's lower part while holding its upper part securely.

      NOTICE:
      1. The claw will not disengage unless the front bumper cover's upper part is securely held.
      2. Do not forcibly pull up the front bumper. This will deform the claw.

  1. w/ Fog light:
    Disconnect the 2 fog light connectors.



5. REMOVE HEADLIGHT ASSEMBLY LH


E070529E01
  1. Remove the 3 screws.

  1. Pull the headlight towards the front of the vehicle, disconnect all connectors and remove the headlight.



6. REMOVE NO. 1 HEADLIGHT BULB (w/o HID Headlight System)


    E073676E01
  1. Turn the headlight socket cover in the direction indicated by the arrow in the illustration to remove it.



    E070537E01
  1. Push the set spring in the direction indicated by the arrow in the illustration to remove the No. 1 headlight bulb.

    NOTICE:
    Do not touch the bulb glass with your fingers.



7. REMOVE HID HEADLIGHT BULB (w/ HID Headlight System)


    E070532E01
  1. Turn the headlight socket cover in the direction indicated by the arrow in the illustration to remove it.



    E070533E01
  1. Turn the headlight light control ECU socket in the direction indicated by the arrow in the illustration to remove it.



    E070534E01
  1. Push the set spring in the direction indicated by the arrow in the illustration and remove the discharge headlight bulb.

    NOTICE:
    Do not touch the bulb glass with your fingers.



8. REMOVE CLEARANCE LIGHT BULB


    E070531E01
  1. Turn the clearance light socket and bulb in the direction indicated by the arrow in the illustration to remove them.



9. REMOVE FRONT TURN SIGNAL LIGHT BULB


    E070530E02
  1. Rotate the front turn signal light socket and bulb in the direction indicated by the arrow in the illustration to remove them.



10. REMOVE HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY (w/ HID Headlight System)


    E070535E01
  1. Remove the 4 screws, headlight cover and gasket.



    I038408E01
  1. Remove the 2 screws.



    E074102E01
  1. Disengage the claw and disconnect the connector, and then remove the headlight light control ECU.

    HINT:
    If the bulb socket cannot be removed due to interference with the reflector, turn the aiming screw counterclockwise, move the reflector, and then remove the bulb socket.



11. REMOVE HEADLIGHT LEVERING MOTOR ASSEMBLY LH (w/ HID Headlight System)


    I040081E03
  1. Rotate the headlight leveling motor in the direction indicated by arrow (1) in the illustration.

  1. Rotate the aiming screw on the headlight leveling motor in the direction indicated by arrow (2) in the illustration and remove the shaft.

  1. Pull the headlight leveling motor towards you to remove it.